AAA Card Challenge #62: Anything Goes!

by Justine
0 comment

Hi crafters, I’m back with another creation for the AAA Card Challenge Anything Goes. Today I created this clean and simple butterfly shaker using the amazing Floral and Flutter Die from Concord and 9th! Because I have two videos coming out already today, I did not create a video for this card, however, I explain how I made it below.

  1. Cut a card base that measures 4 1/4 x 5 1/2 inches. Cut a card panel that measures 4 x 5 1/4 inches. Both should be white cardstock.
  2. Die cut the butterfly in the middle of the panel. Centre it onto the card base and draw a pencil line around the butterfly on the card base. Add acetate to the back of the panel to create a window. 
  3. On the base, go around the butterfly you traced using 3D foam tape. Add the bits inside the foam tape and stick the panel onto the card base.
  4. Stamp the sentiment. 
  5. Glue the Die Cut butterfly onto the window panel

Supply List: Affiliate Links used where possible. This means I receive a small commission when you shop through the links at no cost to you. I hope if you like my blog you will support me by clicking through these links to make your purchases.

Concord & 9th FLORAL & FLUTER Die 10065C9 Concord & 9th MAP LOVE Clear Stamp Set 10019C9 Simon Says Stamp SHAKER SHACK bead24 Shake It Up Neenah Classic Crest 80 LB SMOOTH SOLAR WHITE Paper Pack 25 Sheets Neenah Classic Crest 110 LB SMOOTH SOLAR WHITE Paper Pack 25 Sheets
Crafter’s Companion HEAT RESISTANT ACETATE Pack CC-HRA-5PK DoCrafts 3D FOAM TAPE 9mm x 5m Stick It STI7201 Sizzix BIG SHOT MACHINE Gray And White 660425 Tombow MONO MULTI Liquid Glue Tsukineko VersaFine ONYX BLACK Ink Pad VF-82

InLinkz.com

You may also like

Leave a Comment

This website uses cookies to improve your experience. We'll assume you're ok with this, but you can opt-out if you wish. Accept Read More